Significance and Use
These test methods are designed primarily for specimens prepared in a laboratory under standardized conditions such as may be used to provide data for development and control of rubber compounds and methods of manufacture. With slight modifications as indicated, Methods A, B, C, D, and E are also used for obtaining comparative adhesion test values of production parts whenever the design permits preparation of suitable test specimens. Methods A, B, C, and D are applicable in the case of many products in which rubber is used for controlling vibration.
Scope
1.1 These test methods cover procedures for testing the static adhesional strength of rubber to rigid materials (in most cases metals).
Method A—Rubber Part Assembled Between Two Parallel Metal Plates.
Method B—90o Stripping Test-Rubber Part Assembled to One Metal Plate.
Method C—Measuring Adhesion of Rubber to Metal with a Conical Specimen.
Method D—Adhesion Test-Post-Vulcanization (PV) Bonding of Rubber to Metal.
Method E—90 Stripping Test-Rubber Tank Lining-Assembled to One Metal Plate.
Method F—Rubber Part Assembled Between Two Parallel Convex-Shaped Metal Plates
Method G—Measuring Bond Durability for Rubber-to-Metal Bonded Components with a Double Shear Cylindrical Specimen
Method H—Measuring Bond Durability for Rubber-to Metal Bonded Components with a Quadruple Shear Cylinder Speciment
1.2 While the test method may be used with a wide variety of rigid materials, use of materials other than metals is the exception. For this reason, we have used the word "metal" in the text rather than "rigid materials."
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
