Significance and Use
5.1 The procedures in this standard can be used for acceptance testing of commercial shipments of coated and laminated fabrics for architectural use since these test methods have been used extensively in the trade for acceptance testing. Caution is advised, however, when testing adhesion of coating to fabric and breaking strength after crease fold because between laboratory precision is known to be poor (see 24.2). For these cases, comparative tests conducted, as directed in 5.1.1, may be advisable.
5.1.1 In cases of a dispute arising from differences in reported test results when using Test Methods D4851 for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using appropriate statistical analysis for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results with consideration of the known bias.
5.2 The uses and significance of specific properties are discussed in the appropriate sections of specific test methods.
Scope
1.1 These test methods cover the testing of coated and laminated fabrics made primarily for use in fabric roof systems. These coated and laminated fabrics are generally in either an air supported or tension supported construction of fabric roof systems.
1.2 These methods can be used for most fiber-based, coated and laminated architectural fabrics.
1.3 This standard includes the following sections that provide test procedures for coated and laminated architectural fabrics:
|
| Section |
| Fabric Count |  8 |
| Mass per Unit Area |  9 |
| Fabric Thickness | 10 |
| Fabric Width | 11 |
| Fabric Length | 12 |
| Fabric Bow | 13 |
| Adhesion of Coating to Fabric | 14 |
| Uniaxial Elongation Under Static Load | 15 |
| Fabric Breaking Force | 16 |
| Breaking Strength After Crease Fold | 17 |
| Elongation at Break | 18 |
| Fabric Trapezoid Tear Force | 19 |
| Resistance to Accelerated Weathering | 20 |
| Solar Optical Properties | 21 |
| Fabric Flame Resistance | 22 |
| Noise Reduction Coefficient | 23 |
1.4 These test methods include only testing procedures and do not include specifications or tolerances. They are intended as a guide for specifications. Any of these methods may be used in material specifications to evaluate requirements for a specific end use as related to a particular job.
1.5 The values stated in either SI or inch-pound units are to regarded separately as the standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
