Significance and Use
This bench test method was designed as a replacement for Test Method D 5844
5.1.1 Correlation between these two test methods has been demonstrated for most, but not all, of the test oils evaluated.
Scope
1.1 This test method covers a Ball Rust Test (BRT) procedure for evaluating the anti-rust ability of fluid lubricants. The procedure is particularly suitable for the evaluation of automotive engine oils under low-temperature, acidic service conditions.
1.2 Information Letters are published occasionally by the ASTM Test Monitoring Center (TMC) to update this test method. Copies of these letters can be obtained by writing the center.
1.3 The values stated in either SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, use each system independently of the other, without combining values in any way.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 7.1.1-7.1.3 and 8.2.1.1.
