Significance and Use
The test method is useful for the following:
Classification of Powders—The cohesion and angle of internal friction are flowability indicators of powders and can be used to classify the powders.
Quality Control—For a number of industrial applications flowability factors are used to compare the material flowability at different times during production. The material produced has to be held within given limits for each application and each powder so as to ensure trouble-free operation.
Material Engineering—Powder properties are influenced by particle size, particle size distribution, fat content, humidity and other parameters. By selecting the correct parameters and the correct mixtures of powders, the required mechanical properties of the product are achieved.
Design of Handling Equipment—For certain storage and conveyor equipment mathematical models exist which require the mechanical properties of powders.
Note 2—The quality of the result produced by this standard is dependent on the competence of personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D 3740
Scope
1.1 This test method is applied to the measurement of the mechanical properties of powders as a function of normal stress.
1.2 This apparatus is suitable measuring the properties of powders and other bulk solids, up to a particle size of 5000 micron.
1.3 This method comprises four different test procedures for the determination of powder mechanical properties:
1.3.1 Test A—Measurement of INTERNAL FRICTION as a function of normal stress.
1.3.2 Test B—Measurement of WALL FRICTION as a function of normal stress.
1.3.3 Test C—Measurement of BULK DENSITY as a function of normal stress and time.
1.3.4 Test D—Measurement of DEGRADATION as a function of normal stress.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026
1.4.1 The procedures used to specify how data are collected/recorded or calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives, and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
