Scope
1.1 This guide covers the use of coal combustion products (CCPs) for surface coal mine reclamation applications, as in beneficial use for reestablishing land contours, highwall reclamation, and other reclamation activities requiring fills or soil replacement. The purpose of this standard is to provide guidance on identification of CCPs with appropriate engineering and environmental performance appropriate for surface mine re-contouring and highwall reclamation applications. It does not apply to underground mine reclamation applications. There are many important differences in physical and chemical characteristics among the various types of CCPs available for use in mine reclamation. CCPs proposed for each project must be investigated thoroughly to design CCP placement activities to meet the project objectives. This guide provides procedures for consideration of engineering, economic, and environmental factors in the development of such applications, and should be used in conjunction with professional judgement. This guide is not intended to replace the standard of care by which the adequacy of a given professional service must be judged, nor should this guide be applied without consideration of a project's unique aspects.
1.2 The utilization of CCPs under this guide is a component of a pollution prevention program; Guide E 1609 describes pollution prevention activities in more detail. Utilization of CCPs in this manner conserves land, natural resources, and energy.
1.3 This guide applies to CCPs produced primarily from the combustion of coal.
1.4 The testing, engineering, and construction practices for using CCPs in mine reclamation are similar to generally accepted practices for using other materials, including cement and soils, in mine reclamation. For guidance on structural fills to be constructed at mine sites, see applicable ASTM guide for coal ash structural fills.
1.5 Regulations governing the use of CCPs vary by state. The user of this standard guide has the responsibility to determine and comply with applicable regulations.
1.6 The values stated in foot-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
