Significance and Use
4.1 The inclusion of the following paragraph, or a suitable equivalent, in any standard (preferably after the section on Scope) is due notification that the apparatus and reagents required in that standard are subject to the recommendations prescribed in these practices.
|
| “Apparatus and Reagents—Apparatus and reagents required for each determination are listed in separate sections preceding the procedure. Apparatus, standard solutions, and certain other reagents should conform to the requirements prescribed in E01 Practices E50, for Apparatus, Reagents, and Safety Considerations for Chemical Analysis of Metals, Ores, and Related Materials.” |
|
† ACS specification exists but does not cover all requirements.
* Reagent on which ACS specifications exist.
4.2 It is assumed that the users of these practices will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory.
Scope
1.1 These practices cover laboratory apparatus and reagents that are required for the chemical analysis of metals, ores and related materials by standard methods of E01. Detailed descriptions of recommended apparatus and detailed instructions for the preparation of standard solutions and certain nonstandardized reagents will be found listed or specified in the individual methods of analysis. Included here are general recommendations on the purity of reagents and protective measures for the use of hazardous reagents.
1.2 These recommendations are intended to apply to the E01 methods of chemical analysis of metals, ores and related materials when definite reference is made to these practices, as covered in Section 4.
1.3 The values stated in SI units are regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 8.
Note 1: The use of the verbs “shall” and “must” (with their obligatory third person meaning) in this standard has been confined to those aspects of laboratory safety where regulatory requirements are known to exist. Such regulations, however, are beyond the scope of these practices.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
