Scope
1.1 This specification covers non-integral locking devices used to increase safety on unloaded firearms.
1.2 This specification contains functional, operational, and safety requirements for non-integral firearm locking devices. Included are function descriptions, force tests, and surreptitious entry tests as set forth in Section 5.
1.3 The specification is intended to apply only to non-integral locks or locking mechanisms applied to, in, around, or about a firearm, either external to the firearm or by some method of introduction to or within the firearm. The specification is not intended to set evaluation standards by which safety levers, firing pin blocks, or other traditional discharge prevention mechanisms are evaluated, notwithstanding the fact that these mechanisms may prevent inadvertent discharge. This specification is not applicable to devices used for, or intended for, the prevention of theft or other intentional misuse of firearms.
Note 1: Tests described are laboratory type tests and although they may simulate some field conditions, they do not duplicate all field test conditions.
Note 2: There is no apparent comparable ISO/IEC standard.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
