BS 3HR 504:2011

Specification for nickel-chromium-titanium heat-resisting alloy bar and wire for rivets and rivets (Maximum diameter or minor sectional dimension 20 mm) (Nickel base, Cr 19.5, Ti 0.4). | Status: Confirmed, Current

1 Scope This British Standard specifies requirements for nickel-chromium- titanium heat-resisting alloy supplied in the following forms and as rivets.

1. a) Bar: annealed, designation HR 504A.
2. b) Wire: annealed, designation HR 504B.

2 Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

• BS HR 100, Procedure for inspection, testing and acceptance of wrought heat resisting alloys