BS 8621:2007+A2:2012

Thief resistant lock assembly. Keyless egress. | Status: Superseded, Withdrawn

1 Scope This British Standard specifies performance requirements and test methods for a thief resistant mechanically operated single-point lock assembly (including locking plates, fixing screws, fitting instructions, cylinders and protective furniture where appropriate) that:

1. a) incorporates a lock conforming to BS EN 12209 field of door application grades A, B, C, D, E, F or J, i.e. a lock that can always be unlocked from the inside without a key thereby only allowing keyless egress; and
2. b) is used in doors, window doors and entrance doors in buildings.

This standard does not cover thief resistant lock assemblies that only allow egress using a removable key, or lock assemblies that provide a secure (no egress) mode in addition to keyless egress.

NOTE 1 Thief resistant lock assemblies that only allow egress using a key or assemblies that provide a secure (no egress) mode in addition to keyless egress are specified in separate standards, BS 3621 and BS 10621 (respectively), because they are sufficiently different in terms of what they offer for means of escape (from fire) and security.

NOTE 2 It is possible that lock assemblies conforming to this standard are not suitable for use on doors constructed from certain types of material, e.g. plastic or aluminium. The marking on the packaging of the lock assembly will provide this information in accordance with 9.2.

NOTE 3 A lock or latch assembly conforming to this standard can be included as part of an exit device that conforms to BS EN 179 or BS EN 1125.