BS 8621:2017+A1:2024

Lock assemblies operated by key from the outside of the door and by handle or thumb turn from the inside of the door. | Status: Current

1 Scope This British Standard specifies performance requirements and test methods for a thief‑resistant mechanically operated single-point lock assembly (including locking plates, fixing screws, fitting instructions, cylinders and protective furniture where appropriate) that:

1. a) incorporates a lock conforming to BS EN 12209:2016 [no rendering defined for element: std-id ] 10.3403/30298569 that can be unlocked from the inside without a key thereby only allowing keyless egress; and
2. b) is used in doors, window doors and entrance doors in buildings.

This standard does not cover thief-resistant lock assemblies that only allow egress using a removable key, or lock assemblies that provide a secure (no egress) mode in addition to keyless egress.

NOTE 1 Thief-resistant lock assemblies that only allow egress using a key or assemblies that provide a secure (no egress) mode in addition to keyless egress are specified in BS 3621 [no rendering defined for element: std-id ] 10.3403/00084380U and BS 10621 [no rendering defined for element: std-id ] 10.3403/30167592U (respectively), because they are sufficiently different in terms of what they offer for means of escape (from fire) and security.

NOTE 2 It is possible that lock assemblies conforming to this standard might not be suitable for use on doors constructed from certain types of material, e.g. plastic or aluminium. See 9.2, which specifies the information to be provided on the marking on the packaging of the lock assembly.

NOTE 3 A lock or latch assembly conforming to this standard can be included as part of an exit device that conforms to BS EN 179 [no rendering defined for element: std-id ] 10.3403/02692055U or BS EN 1125 [no rendering defined for element: std-id ] 10.3403/02671205U.