BS EN 10028-6:2009 Flat products made of steels for pressure purposes. Weldable fine grain steels, quenched and tempered
BS EN 10028-6 specifies requirements for flat products for pressure equipments made of quenched and tempered steels. The requirements in EN 10028-1:2007 + A1:2009 also apply.
Once this European Standard is published in the EU Official Journal (OJEU) under Directive 97/23/EC, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 97/23/EC is limited to technical data of materials in BS EN 10028-6 and BS EN 10028-1 and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 97/23/EC are satisfied, needs to be done.
Contents of BS EN 10028-6:
- Foreword
- Scope
- Normative references
- Terms and definitions
- Dimensions and tolerances
- Calculation of mass
- Classification and designation
- Classification
- Designation
- Information to be supplied by the purchaser
- Mandatory information
- Options
- Example for ordering
- Requirements
- Steelmaking process
- Delivery condition
- Chemical composition
- Mechanical properties
- Surface condition
- Internal soundness
- Inspection
- Types of inspections and inspections documents
- Tests to be carried out
- Retests
- Sampling
- Test methods
- Marking
- Relationship between this European Standard and the Essential Requirements of EU Directive 97/23/EC
- Bibliography
