BS EN 10210-1:2006

BS EN 10210-1 specifies the technical delivery conditions for hot finished hollow sections of circular, square, rectangular or elliptical forms and applies to hollow sections formed hot, with or without subsequent heat treatment, or formed cold with subsequent heat treatment to obtain equivalent metallurgical conditions to those obtained in the hot formed product.

The requirements for tolerances, dimensions and sectional properties are contained in BS EN 10210-2.

Contents

• Scope
• Normative references
• Terms, definitions and symbols
• Classification and designation
• Information to be obtained by the manufacturer
• Mandatory information
• Options
• Example of an order
• Requirements
• Steel manufacturing process
• Structural hollow section manufacturing process
• Delivery condition
• Chemical composition
• Mechanical properties
• Technological properties
• Surface condition
• Non-destructive testing of welds
• Tolerances and mass
• Inspection
• Types of inspection
• Types of inspection document
• Summary of inspection
• Sampling
• Frequency of tests
• Preparation of samples and test pieces
• Test methods
• Chemical analysis
• Mechanical tests
• Visual inspection and dimensional check
• Non-destructive testing
• Retests, sorting and reprocessing
• Marking
• Evaluation of conformity
• Annex A (normative) Structural hollow sections of non-alloy quality steels - Chemical composition and mechanical properties
• Annex B (normative) Structural hollow sections of fine grain steels - Chemical composition and mechanical properties
• Annex C (normative) Location of samples and test pieces
• Annex D (normative) Evaluation of conformity
• Annex ZA (informative) Clauses of this European Standard addressing the provisions of the EU
• Construction Products Directive
• Bibliography

BS EN 10210-1:2006 supersedes BS EN 10210-1:1994