BS EN 12106:2025

Plastics piping systems. Polyethylene (PE), crosslinked polyethylene (PE-X) and unplasticized polyamide (PA-U) pipes. Test method for the resistance to internal pressure after application of squeeze-off. | Status: Current

1 Scope This document specifies a method to determine the resistance to internal pressure of polyethylene (PE), crosslinked polyethylene (PE-X) and unplasticized (PA-U) pipes to verify the condition of the pipe after being subjected to a squeeze-off procedure. The equipment and procedure used to prepare the test samples and test parameters are given in this document, i.e.:

1. a) the diameter and series of the pipe to be tested (see 6.1);
2. b) the number of test pieces (see 6.2);
3. c) the parameters for the hydrostatic strength tests (see 7.6).

NOTE 1 Further information on the squeeze-off procedure is given in EN 12007‑2 and ISO/TS 10839 for polyethylene, and CEN/TS 12007‑6 for unplasticized polyamide.

NOTE 2 The squeeze-off procedure is specified to limit gas flow to allow maintenance, repair or to make network connections. Squeeze-off is used in an emergency for pipes carrying other media.