What is BS EN 125:2010+A1-Thermoelectric flame supervision devices about?
BS EN 125:2010+A1 is a European Standard that specifies the safety, construction, and performance requirements for thermoelectric flame supervision devices, energized by a thermocouple intended for use with gas burners, gas appliances and similar use, hereafter referred to as "controls".
BS EN 125:2010+A1 is applicable to controls with declared maximum inlet pressures up to and including 500 kPa (5 bar) of nominal connection sizes up to and including DN 50 for use with one or more fuel gases in accordance with EN 437.
BS EN 125:2010+A1 not applicable to:
- The thermocouple
- Controls which use auxiliary energy (e.g. electrical energy supplied externally)
Who is BS EN 125:2010+A1-Thermoelectric flame supervision devices for?
BS EN 125:2010+A1 on gas burning appliances is useful for:
- Construction, automotive, mechanical Industries
- Manufacturers of pressure vessels
- Manufacturers of aircraft & aerospace
- Shipbuilding industry
- Gas appliances manufacturers
- Gas stove and cooktop manufacturers
Why should you use BS EN 125:2010+A1-Thermoelectric flame supervision devices?
A gas burner is a device that generates a controlled flame by combining a fuel gas, such as acetylene, natural gas, or propane, with an oxidizer, such as ambient air or supplied oxygen, and permitting ignition and combustion.
BS EN 125:2010+A1 provides you with the safety, construction, and performance requirements for thermoelectric flame supervision devices.
Compliance with the best industry guidance on thermoelectric flame supervision devices, BS EN 125:2010+A1, may help you optimize performance and standardise by setting the best safety requirements.
What’s changed since the last update?
BS EN 125:2010+A1:2015 supersedes BS EN 125:2010 which is withdrawn. BS EN 125:2010+A1:2015 includes some technical changes with respect to BS EN 125:2010. These include:
- Alignment with EN 13611:2007
- Updating of Clause 2, Normative references
- New declaration of nominal diameter and maximum inlet pressure
