What is BS EN 12977-3- custom-built solar system about?
BS EN 12977 discusses thermal solar systems and components. BS EN 129773 is the third part of BS EN 12977 multi-series and discusses performance test methods for solar water heater stores.
BS EN 12977-3 specifies test methods for the performance characterization of stores that are intended for use in small custom-built systems as specified in EN 12977-1:2018. Stores tested according to BS EN 12977-3 are commonly used in solar heating systems.
However, the thermal performance of all other thermal stores with water as a storage medium can also be assessed according to the test methods specified in BS EN 12977-3. BS EN 12977-3 applies to stores with a nominal volume between 50 l and 3 000 l.
Note: BS EN 12977-3 does not apply to combistores. Performance test methods for solar combistores are specified in EN 12977-4:2018.
Who is BS EN 12977-3- custom-built solar system for?
BS EN 12977-3 on thermal solar systems and components is useful for:
- Solar-powered products manufacturers
- Design engineers
- Quality control personnel
Why should you use BS EN 12977-3- custom-built solar system?
Custom-built solar heating systems are either uniquely built or assembled by choosing from an assortment of components. Systems of this category are regarded as a set of components. The components are separately tested, and test results are integrated into an assessment of the whole system.
The test methods for stores of solar heating systems as described in BS EN 12977-3 are required for the determination of the thermal performance of small custom-built systems as specified in EN 12977-1:2018. The test method described in BS EN 12977-3 delivers a complete set of parameters, which are needed for the simulation of the thermal behaviour of a store being part of a small custom-built solar heating system.
