BS EN 14286:2008 Aluminium and aluminium alloys. Weldable rolled products for tanks for the storage and transportation of dangerous goods
BS EN 14286 contains specifications for aluminium alloy products intended for tanks for the storage and transportation of dangerous goods. It particularly applies to those used for of gasoline and other liquid hydrocarbons.
BS EN 14286 specifies technical conditions of inspection and delivery, the mechanical properties, the tolerances on dimensions and form of rolled semi-finished aluminium alloy products.
BS EN 14286 applies to hot or cold-rolled strip, sheet and plate with a thickness from 3,0 mm and up to and including 12,0 mm used as a wall material.
Compliance with BS EN 14286 does not ensure compliance with national or international regulations.
Contents of BS EN 14286:
- Foreword
- Introduction
- Scope
- Normative references
- Terms and definitions
- Selection of materials
- Designation of the products
- Ordering information
- Requirements
- General
- Technical conditions for inspection and delivery
- Mechanical properties
- Surface conditions
- Tolerances on dimensions and form
- Inspection
- Inspections to be carried out
- Type and content of inspection documents
- Quality assurance
- Marking
- Explanation of temper designations used in Table 1 based on definitions of EN 515
- Bibliography
