BS EN 16585-2:2025

This document describes the specific ‘Design for PRM use’ requirements applying to rolling stock and the assessment of those requirements. The following applies to this document:

• The definitions and requirements describe specific aspects of ‘Design for PRM use’ required by persons with disabilities and persons with reduced mobility as defined in the PRM TSI.

• This document defines elements which are universally valid for obstacle-free travelling relating to elements for sitting, standing and moving. The definitions and requirements of this document are to be used for rolling stock applications.

• This document only refers to aspects of accessibility for PRM passengers; It does not define general requirements and general definitions.

• This document assumes that the rolling stock is in its defined operating condition.

• Where minimum or maximum dimensions are quoted these are absolute NOT nominal requirements.

The 'Equipment and components' standard is written in three parts:

• Part 1 contains:

  • toilets.

• This document is Part 2 and contains:

  • handholds;

  • seats;

  • wheelchair spaces.

• Part 3 contains:

  • clearways;

  • internal doors.