What is BS EN 16617 - Corrugated metal hoses about?
BS EN 16617 is an international standard on pipework that specifies the material requirements, test methods and test procedures for corrugated metal hose. BS EN 16617 is useful in designing and manufacturing good quality hoses.
BS EN 16617 specifies general requirements for material, design, manufacture, testing, marking and documentation of corrugated metal hose assemblies for gas of diameter up to DN 300 for gases of the 2nd and 3rd families according to EN 437.
Note: BS EN 16617 applies to Corrugated metal hose assemblies for gas for the supply of combustible gas and having a maximum operating pressure (MOP) less than or equal to 16 bar.
Note: BS EN 16617 does not apply to:
- Corrugated metal hose assemblies for gas for engines including turbines and internal combustion engines as stated by pressure equipment directive 97/23/EC
- Corrugated metal hose assemblies for the connection of domestic appliances using gaseous fuels according to EN 14800
- Corrugated metal hose assemblies for gas buried in the earth
- Corrugated metal hose assemblies with non–permanent detachable end fittings
- Stainless steel pliable corrugated tubing kits in buildings for gas with an operating pressure up to 0,5 bar (EN 15266)
Note: Users of this BS EN 16617 should consider national standards and existing code of practice in the country of destination.
Who is BS EN 16617 - Corrugated metal hoses for?
BS EN 16617on Pipework is useful for:
- Chemical industries
- Manufacturers of paper and board
- Metal industries
- Oil and gas refineries
- Gas stations
Why should you use BS EN 16617 - Corrugated metal hoses?
Corrugated metal hoses are non-rigid connections for transporting liquids, gases, and semi-solids.
BS EN 16617 specifies the material requirements, test methods and test procedures for Corrugated metal hose. This test method is useful in resisting corrosion, pressure, and high temperature for Corrugated metal hose. The dimensions mentioned in BS EN 16617 is useful in designing, constructing, and assembling these metal hoses. By applying BS EN 16617 you can produce good quality corrugated metal hoses used in the pipework.
