BS EN 1820:2005+A1:2009 Anaesthetic reservoir bags
BS EN 1820 specifies requirements for antistatic and non-antistatic reservoir bags for use with anaesthetic apparatus or lung-ventilator breathing systems. It includes requirements for the design of the neck, size designation, distension and, where relevant, for electrical resistance.
BS EN 1820 is not applicable to special-purpose bags, for example bellows and self-expanding bags. Bags for use with anaesthetic gas scavenging systems are not considered to be anaesthetic reservoir bags and are thus outside the scope of this document.
Contents of BS EN 1820:
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Prevention of electrostatic charges
6 Requirements for bags supplied sterile
7 Marking
8 Information to be supplied by the manufacturer
Annex A (informative) Test for leakage
A.1 Principle
A.2 Apparatus A.3 Procedure
A.4 Expression of results
Annex B (normative) Determination of capacity
B.1 Principle
B.2 Apparatus
B.3 Procedure
B.4 Expression of results
Annex C (normative) Test for security of attachment of plain neck to 22 mm male conical connector 13
C.1 Principle
C.2 Apparatus and materials
C.3 Procedure
Annex D (normative) Test for security of attachment of adaptor of assembled neck to bag
D.2 Apparatus
D.3 Procedure
Annex E (normative) Test for resistance to pressure required to distend the bag (pressure/volume)
E.1 Principle
E.2 Apparatus
E.3 Procedure
E.4 Expression of results
Annex F (informative) Test for resistance to pressure required to distend the bag using air (pressure/volume)
F.1 Principle
F.2 Apparatus
