What is BS EN 3475‑707 - Stabilization of assembly in Cables, electrical, aircraft use about?
BS EN 3475‑707 is an aerospace series that discusses the stability of the assembly.
BS EN 3475‑707 specifies methods for measuring the stability of the twisted assembly. This characteristic is mandatory on the section up to 1 mm².
Note: BS EN 3475‑707 shall be used together with EN 3475-100.
Who is BS EN 3475‑707 - Stabilization of assembly in Cables, electrical, aircraft use for?
BS EN 3475‑707 on stabilization of assembly is useful for:
- Manufacturers of aerospace equipment's and components
- Testing agencies involved in the inspection of aerospace products
- Aeronautical engineers
Why should you use BS EN 3475‑707 - Stabilization of assembly in Cables, electrical, aircraft use?
BS EN 3475‑707 specifies the preparation of specimens and methods. BS EN 3475‑707 states that the measurement must be done on samples directly out of a reel or out of a coil with a minimum of deformation and the test specimen must be cut with (250 ± 10) mm length with sharp scissors to get a clean cut.
BS EN 3475‑707 also conducts visual examinations given the following requirements:
- wires shall not splay on a length superior to half a lay of cable.
- wires shall not splay more than three millimetres.
