What is BS EN 4708-105 - Polyvinylidene fluoride sleeving about ?
BS EN 4708-105 is an international standard for aerospace series that provides guidance on the polyvinylidene fluoride sleeving.
BS EN 4708-105 specifies the required characteristics for a heat-shrinkable, semi-flexible polyvinylidene sleeving for use in aircraft electrical systems at operating temperatures between − 55 °C and 150 °C. This sleeving is basically transparent but may be tinted. It is semi-flexible, tough and abrasion-resistant. It is suitable for use where strain relief and mechanical protection are required, or where their transparent properties are desirable.
It is not suitable for use where contamination from phosphate ester-based hydraulic fluid is possible.
These sleevings are normally supplied with internal diameters up to 25,4 mm for shrink ratios of 2:1.
Sizes other than those specifically listed in BS EN 4708-105 may be available. These items shall be considered to comply with BS EN 4708-105 if they comply with the property requirements listed in Tables 2, 3, and 4 except for dimensions and mass.
Who is BS EN 4708-105 - Polyvinylidene fluoride sleeving for ?
BS EN 4708-105 on polytetrafluoroethylene sleeving is useful for:
- Aerospace avionic and fibre optic technology
- Aircraft electrical manufacturers
- Radars, Satellites, and other defence electronics equipment
- Manufacturers of electrical motors, heaters, transformers, and scientific instruments
- Design engineers for polytetrafluoroethylene sleeves
- Quality control personnel for polytetrafluoroethylene sleeves
Why should you use BS EN 4708-105 - Polyvinylidene fluoride sleeving ?
Polyvinylidene fluoride (PVDF) is a chemical compound used in high-temperature applications.
Polyvinylidene fluoride (PVDF) sleeve is chemical resistant, fireproof, durable, and reliable and used for insulating the cable jacketing in the aircraft and electronics industry, industrial power control systems, high-temperature wiring, etc.
As a manufacturer, you can use BS EN 4708-105 guidance in the production of PVDF-based seals, gaskets, lining, etc.
By using BS EN 4708-105, you can manufacture the best quality sleeves including all the qualities that make it best for use in aircraft.
