What is BS EN 4835 - Adaptors and reducers about?
BS EN 4835 is a European Standard that specifies the installation and removal requirements for adaptors and reducers, threaded, with a lockring for pipe couplings 24° according to EN 4833 and EN 4836.
BS EN 4835 establishes an accurate procedure of adaptor installation, removal, and reinstallation to ensure the repeatability of the installation operation and to ensure effective compliance to sealing and locking requirements.
The adaptor shown on all Figures of BS EN 4835 is given as an example for the 24° internal cone interface according to EN 6123.
This procedure is used for adaptors 24°, for nominal pressure up to 35 000 kPa (5 080 psi).
Who is BS EN 4835 - Adaptors and reducers for?
BS EN 4835 on installation and removal requirements is useful for:
- Aerospace hydraulic systems, fluids, and components manufacturer
- Aircraft electrical manufacturers
- Design engineers for pipe coupling
- Quality control personnel for pipe coupling
Why should you use BS EN 4835 - Adaptors and reducers?
Adapters are used where the size of the connection device or cable is larger than, or equivalent in size, to that of the conduit entry thread of the enclosure. Adapters have a smaller male thread than female thread, whereas reducers have a larger male thread than female thread.
As a manufacturer, you can use BS EN 4835 guidance in the installation and removal of adaptors and reducers.
Using guidelines given in BS EN 4835 you can get accurate installation operations and methods and ensure effective compliance.
By using BS EN 4835, you can manufacture the best quality adaptors and reducers including all the qualities that make it best for use in aircraft.
