BS EN 50065-1:2001+A1:2010 Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. General requirements, frequency bands and electromagnetic disturbances
BS EN 50065-1 applies to electrical equipment using signals in the frequency range 3 kHz to 148,5 kHz to transmit information on low voltage electrical systems, either on the public electricity distribution network or within installations in consumers premises.
BS EN 50065-1 specifies the frequency bands allocated to the different applications, limits for the terminal output voltage in the operating band and limits for conducted and radiated disturbance. It also gives the methods of measurement.
BS EN 50065-1 does not specify the signal modulation methods nor the coding methods nor functional features (except those for the prevention of mutual interference).
Environmental requirements and tests are not included.
In most countries the transmission of information is subject to regulation. Compliance with this standard does not imply permission to establish communication with locations outside the consumer.s installation or with other consumers through the public electricity distribution network where this would not otherwise be allowed.
The object of BS EN 50065-1 is to limit mutual influence between signal transmission equipment in electrical installations and between such equipment and other equipment. In addition this standard is intended to limit interference caused by signal transmission equipment to sensitive electronic equipment. However, complete freedom from such interference cannot be assured.
Contents of BS EN 50065-1:
1 Scope
2 Normative references
3 Definitions
4 Frequency bands
5 Access protocol
6 Transmitter output voltage
7 Disturbance limits
8 Test conditions
9 Inadvertent operation
Annexes
A (normative) Method of measurement of the frequency range over which a transmitter device detects a signal from another device in the frequency range 125 kHz to 140 kHz
B (normative) Method of measurement of the spectral distribution of a transmitting device.s signal in the frequency range 125 kHz to 140 kHz
C (normative) Methods of measurement (9 kHz to 30 MHz)
D (normative) Methods of measurement of disturbance power (30 MHz to 1GHz
E (normative) Attenuation characteristics of measuring instrument above 150 kHz
F (informative)Design for a single artificial network intended to show the performance of a signalling system
