What is BS EN 55013 - Sound and television broadcast receivers about ?
BS EN 55013 discusses sound and television broadcast receivers and associated equipment with a focus on radio disturbance characteristics. BS EN 55013 applies to the generation of electromagnetic energy from sound and television receivers for the reception of broadcast and similar transmissions and from associated equipment. The frequency range covered extends from 9 kHz to 400 GHz.
BS EN 55013 describes the methods of measurement applicable to sound and television receivers or associated equipment and specifies limits for the control of disturbance from such equipment. Information technology equipment (ITE) is excluded, even if intended to be connected to a television broadcast receiver. The telecommunication port of broadcast receivers, intended to be connected to a telecommunication network, is covered by CISPR 22.
Who is BS EN 55013 - Sound and television broadcast receivers for ?
BS EN 55013 on sound and television broadcast receivers is useful for:
- Telecommunication equipment manufacturers
- Telecommunication component manufacturers
- Design engineers
- Quality control personnel
Why should you use BS EN 55013 - Sound and television broadcast receivers ?
BS EN 55013 describes a method that is applicable for the measurement of disturbance power, expressed in terms of available power, produced at the terminals of the associated equipment in the range of 30 MHz to 1 GHz. The standard test signal and operating conditions of the associated equipment under test are given. The method of measurement and the measuring set-up shall be in accordance with CISPR 16-2-2.
BS EN 55013 provides requirements that are considered sufficient to reach adequate emission levels to protect radio broadcast and telecommunication services and to allow other apparatus to operate as intended at a reasonable distance.
With obedience and compliance to BS EN 55013, you can make sure that your services consistently meet and exceed quality expectations.
