BS EN 60255-26:2009

Measuring relays and protection equipment. Electromagnetic compatibility requirements | Status: Revised, Superseded, Withdrawn

1 Scope and object This part of IEC 60255 is applicable to measuring relays and protection equipment for power system protection, including the control, monitoring and process interface equipment used with those systems. This standard specifies the essential requirements for electromagnetic compatibility for measuring relays and protection equipment intended to be used at industrial locations. Measuring relays and protection equipment used in substations and power plants may require higher immunity test levels. For equipment not incorporating electronic circuits, for example electromechanical relays, tests according to this standard are not required. The requirements specified in this standard are applicable to measuring relays and protection equipment in a new condition and all tests specified are type tests only.

1.1 Emission

The object of this standard is to specify limits and test methods, for measuring relays and protection equipment in relation to electromagnetic emissions which may cause interference in other equipment. These emission limits represent electromagnetic compatibility essential requirements and have been selected to ensure that the disturbances generated by measuring relays and protection equipment, operated normally in substations and power plants, do not exceed a level which could prevent other equipment from operating as intended. Test requirements are specified for the enclosure and power supply ports.