BS EN 60335-2-79:2009 Household and similar electrical appliances. Safety. Particular requirements for high pressure cleaners and steam cleaners
BS EN 60335-2 deals with the safety of powered ride-on and walk-behind machines intended for commercial indoor or outdoor use for the following applications:
– Sweeping
– Scrubbing
– Wet or dry pick-up
– Polishing
– Application of wax, sealing products and powder based detergents
– Shampooing.
of floors with an artificial surface. Their cleaning motion is more linear than lateral or periodic.
They may be equipped with a traction drive system. The following power systems are covered:
– Internal combustion engines
– Mains powered motors up to a rated voltage of 250 V for single-phase appliances and 480 V for other appliances
– Battery powered motors.
Battery powered machines may be equipped with a built-in battery charger.
This standard does not apply to
– Machines designed to be part of a production process
– Machines designed for use in corrosive or explosive environments (dust, vapour or gas)
– Machines designed for use on slopes with a gradient exceeding 20 %
– Machines equipped with a power take-off (PTO)
– Machines designed for picking up hazardous dusts as defined in EN 60335-2-69, inflammable substances, or aflame particles
– Floor treatment machines for commercial use as covered by EN 60335-2-67;
– Spray extraction appliances.
Contents of BS EN 60335-2-79:
Introduction
1 Scope
2 Normative references
3 Definitions
4 General requirement
5 General conditions for the tests
6 Classification
7 Marking and instructions
8 Protection against access to live parts
9 Starting of motor-operated appliances
10 Power input and current
11 Heating
12 Void
13 Leakage current and electric strength at operating temperature
14 Transient overvoltages
15 Moisture resistance
16 Leakage current and electric strength
17 Overload protection of transformers and associated circuits
18 Endurance
19 Abnormal operation
20 Stability and mechanical hazards
21 Mechanical strength
22 Construction
23 Internal wiring
24 Components
25 Supply connection and external flexible cords
26 Terminals for external conductors
27 Provision for earthing
28 Screws and connections
29 Clearances, creepage distances and solid insulation
30 Resistance to heat and fire
31 Resistance to rusting
32 Radiation, toxicity and similar hazards
