What is BS EN 60512-29-100 - M12 style connectors about?
BS EN 60512-29-100 is an international standard for Connectors for electronic equipment that specifies the test requirements, test methods, and test procedure for measuring the 100 MHz and 500 MHz connectors. By using BS EN 60512-29-100 you can construct and assemble good quality M12 style connectors.
BS EN 60512-29-100 specifies the test methods for transmission performance for M12-style connectors up to 500 MHz. It is also suitable for testing lower frequency connectors if they meet the requirements of the detail specifications and of this standard.
Note: For the transfer impedance (ZT) test, see IEC 60512-26-100, test 26e. For the coupling, attenuation sees ISO/IEC 11801. All test methods apply for two and four-pair connectors.
Note: All figures show equipment for connectors according to IEC 61076-2-109 as an example.
Note: All figures show schemes for four-pair cabling and are also suitable for two-pair cabling.
Who is BS EN 60512-29-100 - M12 style connectors for?
BS EN 60512-29-100 on Connectors is useful for:
- Manufacturers of electronic devices
- Manufacturers of automotive parts
- Manufacturers of circuits
- Electronic engineers
- Manufacturers of semiconductors
- Manufacturers of medical equipment
Why should you use BS EN 60512-29-100 - M12 style connectors?
Connectors are electromechanical components used for joining electronic conductors. These connectors are useful in creating electrical circuits.
BS EN 60512-29-100 specifies the test method and test procedures for M12 style connectors. This test method helps in measuring the 100 MHz and 500 MHz connectors. These measuring test methods are as follows:
- Insertion loss,
- Return loss
- Near-end crosstalk (NEXT)
- Far-end crosstalk (FEXT)
- Transfer impedance (ZT)
- Transverse conversion loss (TCL)
- Transverse conversion transfer loss (TCTL),
- Coupling attenuation
This is useful in evaluating the transmission performance of connectors and also helps in verifying the requirements used in connectors are appropriate or not.
By applying BS EN 60512-29-100 you can design, manufacture, and assemble good quality M12 style connectors.
