BS EN 61000-4-17:1999+A2:2009, IEC 61000-4-17:1999 Electromagnetic compatibility (EMC). Testing and measurement techniques. Ripple on d.c. input power port immunity test
BS EN 61000-4-17 establishes a common and reproducible basis for testing, in a laboratory, electrical and electronic equipment when subjected to ripple voltages such as those generated by rectifier systems and/or auxiliary service battery chargers overlaying on d.c. power supply sources.
BS EN 61000-4-17 defines:
– Test voltage waveform;
– Range of test levels;
– Test generator;
– Test set-up;
– Test procedure.
BS EN 61000-4-17 defines test methods for immunity to ripple at the d.c. input power port of electrical or electronic equipment.
BS EN 61000-4-17 is applicable to low-voltage d.c. power ports of equipment supplied by external rectifier systems, or batteries which are being charged.
The test described in BS EN 61000-4-17 applies to electrical or electronic equipment and systems. It also applies to modules or subsystems whenever the equipment under test (EUT) rated power is greater than the test generator capacity specified in clause 6.
This test does not apply to equipment connected to battery charger systems incorporating switch mode converters.
BS EN 61000-4-17 does not specify the tests to be applied to particular apparatus or systems. Its main aim is to give a general basic reference to IEC product committees. These product committees (or users or manufacturers of equipment) remain responsible for the appropriate choice of the test and the severity level to be applied to their equipment.
Dedicated test procedures are in use for testing specific categories of electrical or electronic equipment, e.g. equipment connected to d.c. supply network of telephone switching centres; the related product committees should evaluate the relevance and applicability of the test procedure specified in this basic standard.
Contents of BS EN 61000-4-17:
Scope
2 Normative references
3 General
4 Definitions
5 Test levels and waveform
6 Test generator
6.1 Characteristics and performance of the generator
6.2 Verification of the characteristics of the generator
7 Test set-up
8 Test procedure
8.1 Laboratory reference conditions
8.1.1 Climatic conditions
8.1.2 Electromagnetic conditions
8.2 Execution of the test
9 Evaluation of test results
10 Test report
Annex A (informative) Information on the phenomenon
