What is BS EN 61400-13 - Measurement of mechanical load in wind turbines about?
BS EN 61400-13 discusses wind turbines with a focus on the measurement of mechanical loads.
BS EN 61400-13 is the 13th part of the BS EN 61400 multi-series on wind turbines that describes the measurement of fundamental structural loads on wind turbines for the purpose of the load simulation model validation.
BS EN 61400-13 prescribes the requirements and recommendations for site selection, signal selection, data acquisition, calibration, data verification, measurement load cases, capture matrix, post-processing, uncertainty determination, and reporting. Informative annexes are also provided to improve understanding of testing methods.
The methods described in BS EN 61400-13 are used for mechanical loads measurements for other purposes such as obtaining a measured statistical representation of loads, direct measurements of the design loads, safety and function testing, or measurement of component loads. If these methods are used for an alternative objective or used for an unconventional wind turbine design, the required signals, measurement load cases, capture matrix, and post processing methods should be evaluated and if needed adjusted to fit the objective.
Who is BS EN 61400-13-Measurement of mechanical load in wind turbines for?
BS EN 61400-13 on wind turbines is applicable to:
- Wind energy generation systems
- Wind power stations
- Transmission system operators (TSOs)
- Distribution system operators (DSOs)
- Environmental research bodies
- Certification and regulatory bodies
Why should you use BS EN 61400-13-Measurement of mechanical load in wind turbines?
In the process of the structural design of a wind turbine, a thorough understanding of, and accurate quantification of, the loading is of utmost importance. In the design stage, loads can be predicted with aeroelastic models and codes. However, such models have their shortcomings and uncertainties, and they always need to be validated by measurement.
BS EN 61400-13 aims at the test institute, the turbine manufacturer, and the certifying body and clearly defines the minimum requirements for a mechanical loads test resulting in consistent, high quality reproducible test results.
Adopting BS EN 61400-13 helps you to clearly define the minimum requirements for a mechanical loads test resulting in the consistent, high-quality reproducible test result and performance.
