What is BS EN 62058-31 –Acceptance inspection of static meters about?
Electricity metering equipment is used to measure the flow of electricity over a time interval.
BS EN 62058 is a series of standards that discusses acceptance inspection of electricity metering equipment.
BS EN 62058-31 is the 31st part of the IEC 62058 series that specifies particular requirements for acceptance inspection of newly manufactured direct connected or transformer operated static meters for active energy (classes 0.2S, 0.5S, 1 and 2) delivered in lots in quantities above 50.
Who is BS EN 62058-31 - Acceptance inspection of static meters for?
BS EN 62058-31 on general acceptance inspection for static meters is relevant to:
- Static device manufacturers and purchasers
- Power distribution and transmission companies
- Local authorities
- Inspection authorities
- Regulatory bodies
- Engineers
Why should you use BS EN 62058-31- Acceptance inspection of static meters?
BS EN 62058-31 is primarily intended for acceptance inspection between the manufacturer and the purchaser.
BS EN 62058-31 walks you through the test conditions, inspection procedure and criteria for lot acceptance non-acceptance, and disposal of unacceptable lots.
The tests included as a part of the inspection procedure include:
- Test No. 1: AC voltage test
- Test No. 2: Test of no-load condition
- Test No. 3: Starting
- Tests No. 4 to 9: Accuracy tests
- Test No. 10: Verification of the register
If you are a purchaser, by adopting BS EN 62058-31-compliant acceptance inspection guidance, you can determine whether the static meters meet the required technical and performance standards and if they are fit for purpose. This can ultimately enhance your quality control practices.
