What is BS EN 711 - Inland navigation vessels about?
BS EN 711 is a European standard on inland navigation vessels that discusses the criteria for the railings for decks. BS EN 711 applies to railings for decks and gangways on inland navigation vessels. It lays down design, dimensions, strength, and test conditions that have to be observed for safety reasons. The railings protect persons against falling overboard and from one deck to another.
Who is BS EN 711 - Inland navigation vessels for?
BS EN 711 on inland navigation vessels is relevant to:
- Manufacturer of inland navigation vessels
- Manufacturer of railings
- Marine engineer
Why should you use BS EN 711 - Inland navigation vessels?
Inland navigation is a transport system allowing ships and barges to use inland waterways (such as canals, rivers, and lakes). These waterways have inland ports, marinas, quays, and wharves.
BS EN 711 provide guidance on safety requirements, design, railings in work areas, railings in passenger areas, safety dimensions, sturdiness requirements, workmanship, materials, surface protection, testing.
As a user of BS EN 711, you can efficiently install railings for decks and gangways on inland navigation vessels. With obedience and compliance to BS EN 711, you can efficiently manufacture high-quality railings of precise dimensions. With BS EN 711 you can ensure the safety of end-consumers against falling overboard and from one deck to another. BS EN 711 helps you to build consumer trust and confidence in the product. With BS EN 711 you can be ensured that the products consistently meet and exceed quality assurance targets.
What’s changed since the last update?
BS EN 711:2016 supersedes BS EN 711:1996 which is withdrawn.
The following changes have been made in comparison with EN 711:1995:
- A new definition of "spring balanced unit" was added
- The position of the toe rail was defined
- The Figures were improved and removed from the table
- Railing height in working areas was redefined
- The requirement relating to the tensioning of handrails and intermediate rails were added
- Spring balanced units were added
- The minimum diameter for handrails was added
- The design of the mooring equipment was described
- Function in the event of breakage in the material was added
- Designation updated (Clause 7)
- Sample designs for mooring equipment for transitioning to the bulwark and for increased bulwark height added as Annex B;
