What is BS EN IEC 61169‑63 about?
BS EN IEC 61169 is a series on radio-frequency connectors. BS EN IEC 61169‑63 is a sectional specification (SS). BS EN IEC 61169‑63 provides information and rules for the preparation of detailed specifications (DS) for RF coaxial connectors which can preferably be used with RF cables. These connector patterns are for low power, quick connect/disconnect applications using a bayonet-type coupling mechanism and are commonly known as type "BNC" with characteristic impedance 75 Ω.
BS EN IEC 61169‑63 describes the interface dimensions for general purpose connectors, dimensional details for standard test connectors together with gauging information and the mandatory tests. BS EN IEC 61169‑63 applicable to all DS relating to type BNC connectors with characteristic impedance 75 Ω.
BS EN IEC 61169‑63 indicates the recommended performance characteristics to be considered when writing a DS and covers test schedules and inspection requirements.
Who is BS EN IEC 61169‑63 for?
BS EN IEC 61169‑63 on radio-frequency connectors is useful for:
- Manufacturers of telecommunication equipment
- Telecommunication companies
- Design engineers
- Coaxial connector manufacturers and distributors
Why should you use BS EN IEC 61169‑63?
RF connectors are typically used with coaxial cables  and are designed to maintain the shielding that the coaxial design offers. BS EN IEC 61169‑63 defines rules and preparation methods for RF connectors with the inner diameter of outer conductor 6,5 mm (0,256 in) with bayonet lock.
Bayonet lock is a fastening mechanism consisting of a cylindrical male side with one or more radial pins, and a female receptor with matching L-shaped slot(s) and with spring(s) to keep the two parts locked together.
BS EN IEC 61169‑63 discusses the test procedures and dimensions of the RF coaxial connectors which are used to transmit either power or signals. Bayonet locks are more resistant to vibration compared to any other radio-frequency connectors. Therefore, these locks are used in radio-frequency connectors to establish a transmission line for minimum attenuation.
Following the guidelines given in BS EN IEC 61169‑63, you will be able to incorporate the Bayonet lock mechanism into your coaxial cable network.
