What is BS EN IEC 63138‑1 - Multi-channel radio frequency connectors about?
BS EN IEC 63138 is a series on multi-channel radio frequency connectors. A coaxial RF connector (radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range. BS EN IEC 63138‑1 is a generic specification, that specifies general requirements for multi-channel radio-frequency connectors, including terms and definitions, design and construction, ratings and characteristics, climatic categories, IEC type designation, requirements and test procedures, quality assessment, marking, etc.
BS EN IEC 63138‑1 provides the basis for establishing the sectional specifications for various multichannel radiofrequency connector types. BS EN IEC 63138‑1 applies to multi-channel radio frequency connectors (called "connectors", hereinafter) for use in communications, electronics, and other equipment.
Who is BS EN IEC 63138‑1 - Multi-channel radio frequency connectors for?
BS EN IEC 63138‑1 on multi-channel radio frequency connectors is useful for:
- Telecommunication equipment manufacturers
- Telecommunication component manufacturers
- Design engineers
- Quality control personnel
- Research and development facilities
Why should you use BS EN IEC 63138‑1 - Multi-channel radio frequency connectors?
Radiofrequency connectors are typically used with coaxial cables and are designed to maintain the shielding that the coaxial design offers. Better models also minimize the change in transmission line impedance at the connection in order to reduce signal reflection and power loss. BS EN IEC 63138‑1 discusses the connectors and accessories that are designed and constructed to meet the allowance required for proper mating, installation, and maintenance. The inserts in the connectors are designed and constructed to ensure the proper mating and performance of RF channels. When design and construction permit, the connectors should have an indicator to show when mating is in place. The radiofrequency contacts of multi-channel radio frequency connectors should be removable as far as possible. A visual means is provided to indicate when two mating connectors are properly mated.
The relevant specification is not intended to restrict details of construction that do not affect interchangeability or performance or to be used as manufacturing drawings. The interface of the multi-channel radio frequency connectors accessories and the recommended opening hole dimensions of the panel shall be as specified in BS EN IEC 63138‑1. The dimensions and tolerances are given in metric units. During the conversion of dimensions given in inches into millimetres, they are rounded to the nearest 0,001 mm or 0,000 05 in. Where, however, mechanical, and electrical considerations permit, the rounding is usually to the nearest 0,01 mm or 0,000 5 in. Using BS EN IEC 63138‑1 you can specify general requirements for multi-channel radio-frequency connectors.
