What is ISO 10619‑2:2021 about?
ISO 10619‑2 discusses about Rubber and Plastics hoses and tubings. ISO 10619‑2 specifies two methods for measuring the stiffness and one method for the determination of the flexibility of rubber and plastics hoses and tubing when they are bent to a specific radius at sub-ambient temperatures.
Method A is suitable for non-collapsible rubber and plastics hoses and tubing with a bore of up to and including 25 mm. This method provides a means of measuring the stiffness of the hose or tubing when the temperature is reduced from a standard laboratory temperature.
Method B is suitable for rubber and plastics hoses and tubing with a bore of up to 100 mm and provides a means of assessing the flexibility of the hose or tubing when bent around a mandrel at a specified sub-ambient temperature. It can also be used as a routine quality control test.
Method C is suitable for rubber and plastics hoses and tubing with a bore of 100 mm and greater. This method provides a means of measuring the stiffness of the hose and tubing at sub-ambient temperatures. This method is only suitable for hoses and tubing which are non-collapsible.
Who is ISO 10619‑2:2021 for?
ISO 10619‑2 on rubber and plastics hoses and tubing is for:-
- Rubber and plastic hose and tubes manufacturers and suppliers
- PVC hose pipe manufacturers and suppliers
- Entities dealing with plastic tubes and hoses
- Test providers for plastic and rubber hoses and tubes
Why should you use ISO 10619‑2:2021?
ISO 10619‑2:2021 gives you methods for testing and measuring flexibility and stiffness of the rubber and plastics hoses and tubing which assures you the quality performance of hoses and tubes when they are bent to a specific radius at sub-ambient temperatures.
What’s changed since the last update?
BS EN ISO 10619‑2:2021 supersedes BS EN ISO 10619‑2:2018, which is withdrawn. The technical change compared to the previous edition is: the procedure for Method B for hoses greater than 22mm has been changed.
