BS EN ISO 15156-3:2009 - Page 2

Petroleum and natural gas industries. Materials for use in H2S-containing environments in oil and gas production. Cracking-resistant CRAs (corrosion-resistant alloys) and other alloys | Status: Revised, Superseded, Withdrawn

1 Scope This part of ISO 15156 gives requirements and recommendations for the selection and qualification of CRAs (corrosion-resistant alloys) and other alloys for service in equipment used in oil and natural gas production and natural gas treatment plants in H2S-containing environments, whose failure can pose a risk to the health and safety of the public and personnel or to the environment. It can be applied to help to avoid costly corrosion damage to the equipment itself. It supplements, but does not replace, the materials requirements of the appropriate design codes, standards or regulations. This part of ISO 15156 addresses the resistance of these materials to damage that can be caused by sulfide stress-cracking (SSC), stress-corrosion cracking (SCC) and galvanically-induced hydrogen stress cracking (GHSC). This part of ISO 15156 is concerned only with cracking. Loss of material by general (mass loss) or localized corrosion is not addressed. Table 1 provides a non-exhaustive list of equipment to which this part of ISO 15156 is applicable, including permitted exclusions. This part of ISO 15156 applies to the qualification and selection of materials for equipment designed and constructed using conventional elastic design criteria. For designs utilizing plastic criteria (e.g. strain-based and limit-state designs), see ISO 15156‑1:2009, Clause 5. This part of ISO 15156 is not necessarily suitable for application to equipment used in refining or downstream processes and equipment. Table 1 — List of equipment ISO 15156 is applicable to materials used for the following equipment Permitted exclusions a See ISO 15156‑2:2009, A.2.3.2.3 for more information. b See ISO 15156‑2:2009, A.2.3.2.1 for more information. c Wireline lubricators and lubricator connecting devices are not permitted exclusions. d For sucker rod pumps and sucker rods, reference can be made to NACE MR0176. Drilling, well construction and well-servicing equipment Equipment exposed only to drilling fluids of controlled compositiona Drill bits Blowout-preventer (BOP) shear bladesb Drilling riser systems Work strings Wireline and wireline equipmentc Surface and intermediate casing Wells, including subsurface equipment, gas lift equipment, wellheads and christmas trees Sucker rod pumps and sucker rodsd Electric submersible pumps Other artificial lift equipment Slips Flow-lines, gathering lines, field facilities and field processing plants Crude oil storage and handling facilities operating at a total absolute pressure below 0,45 MPa (65 psi) Water-handling equipment Water-handling facilities operating at a total absolute pressure below 0,45 MPa (65 psi) Water injection and water disposal equipment Natural gas treatment plants — Transportation pipelines for liquids, gases and multiphase fluids Lines handling gas prepared for general commercial and domestic use For all equipment above Components loaded only in compression