BS EN ISO 6507-3:2005

Metallic materials - Vickers hardness test - Part 3: Calibration of reference blocks

Method for calibration of reference blocks to be used for indirect verification of Vickers hardness testing machines.

This part of ISO 6507 specifies a method for the calibration of reference blocks to be used for the indirect verification of Vickers hardness testing machines, as specified in ISO 6507-2.

The method in this International Standard is applicable only for indentations with diagonals greater than or equal to 0.020 mm.

This International Standard supersedes BS EN ISO 6507-3:1998 which is withdrawn.

This standard includes the following cross references:

ISO 376:2004, ISO 4287:1997, ISO 6507-1:2005.