BS EN ISO 8503-4:2012

Preparation of steel substrates before application of paints and related products. Surface roughness characteristics of blast-cleaned steel substrates. Method for the calibration of ISO surface profile comparators and for the determination of surface profile. Stylus instrument procedure | Status: Under review, Current

1 Scope This part of ISO 8503 specifies the stylus instrument and describes the procedure for calibrating ISO surface profile comparators conforming to the requirements of ISO 8503-1. This part of ISO 8503 is also applicable to the determination of the surface profile, within the range Ry5¯ = 20 μm to Ry5¯ = 200 μm, of essentially planar blast-cleaned steel. The determination can be carried out on a representative section of the blast-cleaned surface or, if direct observation of the surface is not feasible, on a replica of the surface (see Annex C).

NOTE Where appropriate, this procedure can be used to assess the roughness profile of other abrasive blast-cleaned substrates.

An alternative procedure is described in ISO 8503-3.