BS EN ISO 9445-2:2010

BS EN ISO 9445-2:2010 Continuously cold-rolled stainless steel. Tolerances on dimensions and form. Wide strip and plate/sheet

BS EN ISO 9445 consists of the following parts, under the general title Continuously cold-rolled stainless steel. Tolerances on dimensions and form:

• Part 1: Narrow strip and cut lengths
• Part 2: Wide strip and plate/sheet

BS EN ISO 9445 Part 2 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30 mm to 8,0 mm and in rolling widths from 600 mm to 2 100 mm.

It also applies to slit cold-rolled wide strip in widths less than 600 mm manufactured from wide strip by longitudinal slitting and to cut lengths manufactured from such strip.

Contents of BS EN ISO 9445-2 include:

• Scope
• Normative references
• Terms and definitions
• Information to be supplied by the purchaser
• Type of delivery and delivery condition
• Preferred thicknesses
• Tolerances on thickness for cold-rolled wide strip and products obtained from cold-rolled wide strip
• Tolerances on width for cold-rolled wide strip and products obtained from cold-rolled wide strip
• Preferred coil inner diameters for cold-rolled wide strip and slit cold-rolled wide strip
• Tolerances on length for plate/sheet cut from cold-rolled wide strip and for cut lengths obtained from slit cold-rolled wide strip
• Tolerances on edge camber for cold-rolled wide strip and products obtained from coldrolled wide strip
• Tolerances on squareness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
• Tolerances on flatness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
• Edge waviness tolerances for cold-rolled strip
• Form of coils
• Ordered format for plate/sheet and cut lengths
• Measurement of thickness for cold-rolled wide strip, plate/sheet cut from cold-rolled wide strip, slit cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
• Measurement of width
• Measurement of length
• Measurement of edge camber
• Measurement of squareness
• Measurement of flatness and waviness

BS EN ISO 9445:2010 replaces BS EN ISO 9445:2006 which has been withdrawn.