BS IEC 60462:2010 Nuclear instrumentation. Photomultiplier tubes for scintillation counting. Test procedures
BS IEC 60462 is an International Standard which establishes test procedures for photomultiplier tubes (PMT) for scintillation and Cherenkov detectors.
BS IEC 60462 is applicable to photomultiplier tubes for scintillation and Cherenkov detectors.
Photomultiplier tubes are extensively used in scintillation and Cherenkov counting, both in the detection and analysis of ionizing radiation and for other applications. For such uses, various characteristics are of particular importance and require additional tests to those conducted to measure the general characteristics of PMT. This has made desirable the establishment of standard test procedures so that measurements of these specific characteristics may have the same significance to all manufacturers and users.
The tests described in BS IEC 60462 for PMT to be used in scintillation detectors are supplementary to those tests described in IEC 60306-4, which covers the basic characteristics commonly requiring specification for photomultiplier tubes.
This recommendation is not intended to imply that all tests and procedures described herein are mandatory for every application, but only that those tests carried out on PMT for scintillation and Cherenkov detectors should be performed in accordance with the procedures given in this standard.
Contents of BS IEC 60462:
Foreword
1 Scope and object
2 Normative references
3 Terms, definitions, symbols and abbreviations
3.1 Terms and definitions
3.2 Symbols and abbreviations
3.2.1 Symbols
3.2.2 Abbreviations
4 Test conditions
5 Test procedures for photomultiplier characteristics
5.1 General
5.2 Pulse height characteristics
5.2.1 General
5.2.2 Pulse height resolution measurement
5.2.3 Pulse height linearity measurement
5.2.4 Pulse height stability measurement
5.3 Test procedure for determination of dark current
5.4 Test procedure for time characteristics
5.4.1 General
5.4.2 Photomultiplier rise time measurements
5.4.3 Fall time measurements
5.4.4 Single photo-electron rise time measurements
5.4.5 Transit time spread measurements
Annex A (informative) Light sources
Annex B (informative) Definition of the PMT spectrometric constant
Bibliography
Figure 1 – Pulse height distribution
Figure 2 – Two-pulse method
Figure 3 – Definition of rise, fall time and electron transit time
Figure 4 – Determination of single photo-electron rise time
Figure 5 – Transit time spread
Figure A.1 – Light-emitting diode circuitry
