BS IEC 62232:2011 - Page 3

Determination of RF field strength and SAR in the vicinity of radiocommunication base stations for the purpose of evaluating human exposure. | Status: Superseded, Withdrawn

1 Scope This International Standard provides methods for the determination of radio-frequency (RF) field strength and specific absorption rate (SAR) in the vicinity of radiocommunication base stations (RBS) for the purpose of evaluating human exposure. This standard:

1. a) considers RBS which transmit on one or more antennas using one or more frequencies in the range 300 MHz to 6 GHz;
2. b) describes several RF field strength and SAR measurement and computation methodologies with guidance on their applicability to address both the in situevaluation of installed RBS and laboratory-based evaluations;
3. c) describes how surveyors with a sufficient level of expertise shall establish their specific evaluation procedures appropriate for their evaluation purpose;
4. d) considers the evaluation purposes, namely:
   1. 1) product conformity: to establish that a RBS conforms to a defined set of limit conditions under its intended use;
   2. 2) compliance boundary: to establish the compliance boundary or boundaries for a RBS in relation to a defined set of limit conditions;
   3. 3) to evaluate RF field strength or SAR values at one or more evaluation locations, namely:
      1. i) evaluation location(s) at arbitrary locations outside the control boundary to provide information for interested parties;
      2. ii) evaluation location(s) at the control boundary to confirm validity of control boundary;
      3. iii) evaluation location(s) within the control boundary with the specific conditions relevant to investigate an alleged over-exposure incident;
5. e) provides guidance on how to report, interpret and compare results from different evaluation methodologies and, where the evaluation purpose requires it, determine a justified decision against a limit value;
6. f) provides informative guidance on how to evaluate ambient RF field strength levels in the vicinity of a RBS from RF sources other than the RBS under evaluation and at frequencies within and outside the range 300 MHz to 6 GHz;
7. g) provides short descriptions of the informative example case studies to aid the surveyor given in the companion Technical Report IEC 62669 [54].