BS ISO 13612-1:2014 - Page 2

Heating and cooling systems in buildings. Method for calculation of the system performance and system design for heat pump systems. Design and dimensioning | Status: Current, Confirmed

1 Scope This International Standard is applicable to heat pumps for space heating and cooling, heat pump water heaters (HPWH), and heat pumps with combined space heating and cooling and domestic hot water production, in alternate or simultaneous operation, where the same heat pump is used for space heating and cooling and domestic hot water heating. This part of ISO 13612 establishes the required inputs, calculation methods, and required outputs for heat generation for space heating and domestic hot water production and control of the following heat pump systems:

• — electrically driven vapour compression cycle (VCC) heat pumps;
• — combustion engine-driven VCC heat pumps;
• — thermally-driven vapour absorption cycle (VAC) heat pumps.

This part of ISO 13612 specifies the design and dimensioning criteria for the heating and cooling systems in buildings using heat pumps alone or in combination with other heat generators. These include the following:

• — water–water;
• — brine–water;
• — refrigerant–water (direct expansion systems);
• — air–air;
• — air–water;
• — combined;
• — systems driven by electricity or gas.

This part of ISO 13612 takes into account the heating requirements of attached systems (e.g. domestic hot water, process heat) in the design of heat supply, but does not cover the design of these systems. This part of ISO 13612 covers only the aspects dealing with the heat pump, the interface with the heat distribution and emission system (e.g. buffering system), the control of the whole system, and the aspects dealing with the energy source of the system. Table 1 — Heat pump systems (within this scope) Source system(energy extraction) Sink system(energy rejection) Energy sourcea Mediumb Medium Energy sinkc Exhaust air Outdoor air Refrigerant Refrigerant Air Air Air Air Water Indoor air Water Surface water Ground water Water Water Indoor air Water Air Indoor air Ground Brine (Water) Air Water Water Indoor air Water Refrigerant (Direct expansion) Water Indoor air Water Refrigerant Indoor air a Energy source is the location where the energy is extracted. b Medium is the fluid transported in the corresponding distribution system. c Energy sink is the location where the energy is used; this can be the air-conditioned space or water in case of domestic hot water (DHW) production.