BS ISO 1641-1:2003

End mills and slot drills. Milling cutters with cylindrical shanks | Status: Revised, Superseded, Withdrawn

1 Scope This part of ISO 1642 specifies the general dimensions of the following milling cutters with plain cylindrical, flatted cylindrical and threaded shanks:

• — end mills, flat-ended or ball-nosed — standard series and long series;
• — slot drills — short series and standard series.

The dimensional characteristics of cylindrical shanks are in accordance with ISO 3338-1, ISO 3338-2 and ISO 3338-3.

NOTE These same milling cutters with Morse taper shanks having a tapped hole are dealt with in ISO 1641-2, those with 7/24 taper shanks in ISO 1641-3.

This part of ISO 1641 does not apply to solid hardmetal end mills and slot drills.