What is ISO 1827 - Shear modulus and adhesion to rigid plates about?
ISO 1827 is an international standard on Rubber, vulcanized or thermoplastics that specifies the test methods of shear modulus and adhesion to rigid plates. This ISO 1827 is useful in joining these rigid plates and helps in improving the quality of these four parallel plates.
ISO 1827 specifies methods for the determination of the modulus in shear and the strength of bonds of rubber to metal or other rigid plates, using rubber bonded between four parallel plates.
Note: ISO 1827 covers as follows:
- Method A describes the determination of the modulus in shear.
- Method B describes the determination of the strength of the bonds.
Note: The methods are applicable primarily to test pieces prepared in the laboratory under standard conditions, such as can be used to provide data for the development and control of rubber compounds and methods of manufacture of bonded shear units.
Who is ISO 1827 - Shear modulus and adhesion to rigid plates for?
ISO 1827 on Rubber, vulcanized or thermoplastic is useful for:
- Manufacturers of rubber products
- Manufacturers of automotive parts
- Constructor of building
- Research laboratories
Why should you use ISO 1827 - Shear modulus and adhesion to rigid plates?
Shear modulus is useful in measuring the elastic shear stiffness of a material. The adhesion is useful in joining or bonding these rigid plates by using rubber bonds.
ISO 1827 specifies the test methods and procedure of shear modulus and adhesion to rigid plates. This test method helps in determining the bond strength by measuring the forces of four parallel rigid plates.
With the help of ISO 182, you can reduce the chance of defects or failures in these rigid plates. Applying ISO 1827you can ensure the sustainability of these rigid plates in different climatic conditions. This results in improving the quality of these rigid plates.
What’s changed since the last update?
BS ISO 1827:2016 supersedes BS ISO 1827:2011. BS ISO 1827:2016includes some technical changes with respect to BS ISO 1827:2011. This includes technically revised changed symbols.
