BS ISO 603-4:1999

Bonded abrasive products. Dimensions. Grinding wheels for surface grinding/peripheral grinding | Status: Current, Under review

1 Scope This part of ISO 603 specifies the nominal dimensions, in millimeters, of:

• — Type 1: Straight grinding wheel
• — Type 5: Wheel recessed on one side
• — Type 7: Wheel recessed on both sides
• — Type 20: Wheel relieved on one side
• — Type 21: Wheel relieved on both sides
• — Type 22: Wheel relieved on one side and recessed on the other side
• — Type 23: Wheel relieved and recessed on one side
• — Type 24: Wheel relieved and recessed on one side and recessed on the other side
• — Type 25: Wheel relieved and recessed on one side and relieved on the other side
• — Type 26: Wheel relieved and recessed on both sides.
• — Type 38: Hubbed wheel
• — Type 39: Double hubbed wheel

These bonded abrasive products are intended to be used for the grinding of plane surfaces where the workpiece is secured to a reciprocating table. The workpiece and the grinding wheel are mechanically guided.