What is ISO 8100‑30-Lifts about?
ISO 8100 discusses lifts for the transport of persons and goods. ISO 8100‑30 is the thirtieth part of ISO 8100 multi-series and discusses class I, II, III, and VI lifts installation. ISO 8100‑30 specifies the necessary dimensions to permit the installation of passenger lifts of classes I, II, III, and VI.
These dimensions reflect the requirements for the apparatus.
ISO 8100‑30 is applicable to all new lift installations, irrespective of drive systems, including a car with one entrance, to be installed in a new building. However, for arrangements with a counterweight at the side, a through-entrance configuration is possible. Where relevant, this document is also applicable to an installation in an existing building.
Note: ISO 8100‑30 is not applicable to lifts of rated speed greater than 6,0 m/s.
Who is ISO 8100‑30-Lifts for?
ISO 8100‑30 on lifts for the transport of persons and goods is useful for:
- Lift manufacturers
- Lift installation and maintenances service providers
- Builders
- Civil engineers
- Architects
Why should you use ISO 8100‑30-Lifts?
Lifts ensure that people can move around the building efficiently and make it easy for people with disabilities to access different floors. Installing an elevator in a building needs to be properly planned before implementation to ensure it meets all safety codes and will function correctly.
ISO 8100‑30 guides you with requirements of the global marketplace and includes:
The special needs, access, and full manoeuvrability of persons including persons with physical disabilities.
Appropriate use of stretchers, beds, and ancillary medical equipment in hospitals and nursing homes.
A range of intensive use lifts1) typically used for high-rise buildings for rated speeds of 2,5 m/s to 6,0 m/s.
Rated speeds are mainly based on the Renard series for speeds of up to 2,5 m/s. improved utilization of building space by reducing well (hoistway) sizes where practicable.
What’s changed since the last update?
BS ISO 8100‑30:2019 supersedes BS ISO 4190‑1:2010, which is withdrawn. BS ISO 8100‑30:2019 includes some technical changes with respect to BS ISO 4190‑1:2010.
These include:
- A reference to machine room-less lifts has been added and additional dimensions have been included to cope with common machine room-less lift configurations
- Figure has been changed to include sizes and dimensions of general-purpose lifts with counterweight to side
- Some new and revised car sizes have been included to provide for access by persons including persons with disability
