BS ISO/TR 11696-1:1999 - Page 2

Uses of reaction to fire test results. Application of test results to predict fire performance of internal linings and other building products | Status: Current

1 Scope This Technical Report describes how information on basic values for ignition, spread of flame, rate of heat release and smoke can be used in fire growth models for internal linings and other building products to describe the fire hazard in a limited number of scenarios starting with fire development in a small room. Other scenarios include fire spread in a large compartment and fire propagation down a corridor. The types of models to be used are:

1. a) mathematical models based on fire growth physics, which calculate fire room variables, the results of which may be used for fire safety engineering purposes; and
2. b) generalized engineering calculations.

Sub-models can be included within the above models, provided the consistency of the whole is not prejudiced. The models in general are not limited to one fire scenario. The models should be used to calculate and describe the fire properties of building products in their end-use conditions. The use of models should not be limited by difficult materials, but it is recognized that some products may not be capable of being modelled (for example due to their complex assembly or to their thermoplastic properties). Input parameters for models are based on ISO tests, mainly those in ISO/TR 3814. The quality of a fire model for wall and ceiling linings is assessed by comparison with test results from a full-scale small room test for surface products and by sensitivity analysis on the model itself.