DD 1722-18:2007 specifies requirements for the manufacture of steel mesh site perimeter temporary fencing. It includes requirements for the dimensions and construction of fence components.
Annex A describes a test method to be used by manufacturers or vendors to determine the wind resistance of the fence.
Annex B gives recommendations for the installation of a steel mesh site perimeter temporary fencing system to be provided to vendors and users of the fencing system.
Annex C gives recommendations for the renovation of damaged areas of pre-galvanized coating on fence panels.
Please note this publication is not to be regarded as a British Standard.It is being issued in the Draft for Development (DD) series of publications and is of a provisional nature so that information and experience of its practical application can be obtained.
A review of this Draft for Development will be carried out no later than two years after its publication.
Notification of the start of the review period, with a request for the submission of comments from users of this Draft for Development, will be made in an announcement in the appropriate issue of Update Standards.
According to the replies received, the responsible BSI Committee will judge whether the Draft for Development can be converted into a British Standard or what other action should be taken.
Observations which it is felt should receive attention before the official call for comments are welcomed. These should be sent to: The Secretary of BSI Technical Committee B/201, British Standards House, 389 Chiswick High Road, London, W4 4AL.
