DD IEC/TS 62564-1:2009

DD IEC/TS 62564-1:2009 Aerospace qualified electronic component (AQEC). Microcircuits

This Technical Specification defines the minimum requirements for integrated circuits and semiconductors which are to be designated an “Aerospace Qualified Electronic Component (AQEC)”. It applies to integrated circuits and semiconductors exhibiting the following attributes:

1. A minimum set of requirements, or information provided by the part manufacturer, which

   will allow a standard COTS component to be designated AQEC by the manufacturer;

2. As a minimum, each COTS component (designated AQEC) will have been designed,

   fabricated, assembled, and tested in accordance with the component manufacturer’s

   requirements for standard data book components;

3. Qualification of, and quality systems for, the COTS components to be designated as AQEC

   shall include the manufacturer’s standards, operating procedures, and technical

   specifications. This information shall be available when requested;

4. Components manufactured before the manufacturer has addressed AQEC requirements,

   but utilizing the same processes, are also considered AQEC compliant;

5. Additional desired attributes of a device designated AQEC (that will support AQEC users)

   are found in Annex B of this standard.

Parts qualified to military specifications (except those identified as being for “logistic support” purposes only) are considered AQEC; the remainder of this standard only addresses non-military specification parts.

Parts qualified to AEC-Q100-Revision G, grade 0 through to grade 3 are considered AQEC. For those applications where a 0 °C to +70 °C temperature range is appropriate, grade 4 is also considered to be AQEC. The user shall document that the grade category used is compatible with the application in accordance with their IEC/TS 62239 ECMP.

Contents of DD IEC/TS 62564-1:

• Foreword
• Introduction
• Scope
• Normative references
• Terms, definitions and abbreviations
• Terms and definitions
• Abbreviations
• Technical requirements
• AQEC plan
• AQEC documentation
• General
• AQEC data sheet4.
• Material content
• AQEC visibility
• AQEC life expectancy
• Device technology
• SEE data
• Termination finish
• Third party part numbers
• AQEC performance
• Performance
• Functional parameters
• Known limitations
• Quality system certification
• Component qualification and re-qualification
• AQEC quality assurance and reliability monitoring
• Product Change Notification (PCN)
• Last Time Buy (LTB) notification
• Obsolescence management
• Counterfeit prevention
• User or customer guide
• AQEC material content and construction table
• Additional desired data
• Bibliography