What is ISO/TS 12025 about?
ISO/TS 12025 describes methods for the quantification of nano-objects released from powders because of treatment. This ranges from handling to high energy dispersion, by measuring aerosols liberated after a defined aerosolization procedure. Particle number concentration and size distribution of the aerosol are measured, and the mass concentration is derived.
ISO/TS 12025 provides information on factors to be considered when selecting among the available methods for powder sampling and treatment procedures and specifies minimum requirements for test sample preparation, test protocol development, measuring particle release and reporting data. To characterize the full-size range of particles generated, the measurement of nano-objects, as well as agglomerates and aggregates, are addressed in this document.
Note: ISO/TS 12025 include the characterization of particle sizes within the powder. Tribological methods are excluded where direct mechanical friction is applied to grind or abrade the material.and The quantification of the release of nano-objects from powders described in this document cannot be used as a substitute for dustiness testing or for a health-related risk assessment.
Who is ISO/TS 12025 for?
ISO/TS 12025 on Nanomaterials is applicable to:
- Material scientists and engineers and
- Occupational, health and safety specialists
- Environmental specialists
And applicable to the following industrial sectors:
- Electronic
- Healthcare
- Chemical
- Cosmetics
- composites and energy
Why should you use ISO/TS 12025?
Released nano-objects may affect human health and the environment, depending on the nature and quantity of the nanomaterial. ISO/TS 12025 helps determine the release of nano-objects into the surrounding air from powders resulting from handling is an important consideration in industrial processes.
ISO/TS 12025 helps you to comply with safety and protection standards that are set and monitored by the government or industrial safety committees.
What’s changed since the last update?
PD CEN ISO/TS 12025:2021 supersedes PD CEN ISO/TS 12025:2015, which is withdrawn.
The technical changes compared to the PD CEN ISO/TS 12025:2015, are as follows:
- Revised and updated the Introduction and the Bibliography
- Updated 6.4.1 and 6.4.2 and Annex A with regards to the description and selection of the sample treatment procedure in accordance with new European standards
