PD CEN/TS 16635:2014

Railway application. Design for PRM Use. Equipment and Components onboard Rolling Stock. Toilets. | Status: Superseded, Withdrawn

1 Scope This Technical Specification describes the specific ‘Design for PRM use’ requirements applying to rolling stock on the Trans-European Network (TEN) covered by the TSI for PRM and the assessment of those requirements. Regarding this document, the following statements apply.

• — The definitions and requirements describe specific aspects of ‘Design for PRM use’ required by persons with reduced mobility as defined in the TSI PRM.
• — The definitions and requirements of this specification will be used for rolling stock applications.
• — This specification only refers to aspects of accessibility for PRM passengers; it does not define general requirements and general definitions for specific components and systems.
• — This specification assumes that the vehicle is in the nominal operating condition; any damage or operating failures will not be taken into account when assessing these requirements.
• — Where minimum or maximum dimensions are quoted, these are absolute NOT nominal requirements.

Measurement methods and/or assessment procedures needed to establish a clear pass/fail assessment are provided where necessary.